USA Made Milwaukee M18 battery Adapter connector dock INJECTION MOLDED w wagos

Description

Adapters Proudly Made in the USA.
This adapter slides on your battery easily and locks on just like a Milwaukee drill would for a perfect fit.
This adapter give you easy access to the electrical terminals of an M18 battery for many electrical projects.
This adapter is heavy duty, they are about 5x stronger than my 3d printed adapters, and can be used outdoors.
Adapters are made of glass reinforced nylon 6 (PA6-GF30) which is the same material the drills are made out of.
Adapters have 6 countersunk bolt/screw holes for mounting on walls, vehicles, etc…, bolts/screws not included.
Adapter has 2 6.3 mm brass male spade connectors over molded into the part connected to 2 wire 221 wagos.
Terminals are 20 gauge yellow brass which is 70 percent copper 30 percent zinc for high power applications.
Adapters have pluses and minuses on both sides of them indicating the positive and negative terminals of the M18.
The mold for injection molding these, and the metal stamp for stamping out the brass terminals were made in the USA.
The brass terminals were stamped out in the USA, and the injection molding of this was done in the USA.
DISCLAIMER THESE UNITS DON'T HAVE ANY PROTECTION CIRCUITS IN THEM, USE AT YOUR OWN RISK.
The following sentences are directions on how to use this injection molded Milwaukee M18 battery Adapter.
The first thing you want to do is strip 10 mm off your wires and plug them into the wagos, red to red etc...
The next step is to mount the adapter where you want it, the holes are for M4, #8, or other flat head screws.
Run your preferred wire (silicone, pvc, pe, nylon etc...) and preferred gauge (12, 14, 16 etc...) to your circuit.
Additional helpful Information
You can connect most batteries in parallel and/or series if the batteries are exactly the same.
If you don't want to over discharge your battery use a digital low voltage protector disconnect.
If you want a higher voltage like 24, 36, 48, or 60 volts use a dc to dc step up boost converter.
If you want a lower voltage like 5 or 12 volts use a dc to dc buck converter.